JX Roll Forming provides Cable Management Tray Forming Solutions. The overview below covers profiles, specifications and selection logic.
A cable tray roll forming machine produces cable tray and trunking from 1.5–2.5 mm galvanized, PPGI or carbon steel at 0–15 m/min. One line covers 100–600 mm width and 50–120 mm height with automatic size adjustment, formed through 20 stations and punched on a press under Delta PLC control. Delivery is 80 days, with more than 500 lines built.
A single machine produces tray from 100 mm to 600 mm wide and 50 mm to 120 mm high, with the size changed on the machine rather than by swapping rolls. That range is what makes one line viable for a fabricator serving several projects: the same machine runs a 100 × 50 mm lighting tray and a 600 × 120 mm power tray without a roll change.
| Item | Specification |
|---|---|
| Tray width | 100–600 mm, automatic adjustment |
| Tray height | 50–120 mm, automatic adjustment |
| Coil thickness | 1.5–2.5 mm |
| Material | Galvanized coil, PPGI, carbon steel |
| Yield strength | 250–550 MPa |
| Nominal forming speed | 0–15 m/min |
| Forming stations | 20 |
| Punching | Punch by press machine |
| Decoiler | Manual decoiler |
| Control | Delta PLC (Taiwan), Yaskawa inverter |
| Power supply | 380 V, 50 Hz, 3 phase |
Coil is loaded on the decoiler and fed into a series of roll stages, each of which bends the strip a little closer to the finished tray section. After forming, a press punches the ventilation and fixing holes, then a cutting device cuts the tray to length. Punching and cutting both happen in line, so the tray comes off the machine finished to length.
Perforation is where most of the cycle time goes. A plain tray with two fixing holes per length runs close to the top of the speed range; a fully perforated tray with a dense hole pattern spends far longer in the punch cycle.
An engineer can travel to your factory for installation and commissioning. The machine carries service for its working life, and quality problems not caused by operator error are handled under that commitment.
Q: How many tray sizes can one machine produce?
A: Any size within 100–600 mm width and 50–120 mm height, with automatic adjustment between sizes.
Q: What thickness of coil does it run?
A: 1.5–2.5 mm galvanized, PPGI or carbon steel, yield strength 250–550 MPa.
Q: Are the holes punched in line?
A: Yes. A press punches the hole pattern as the tray is formed, and the tray is cut to length on the same line.
Q: What is the delivery time?
A: 80 days after contract confirmation.
PLC-controlled high-speed cable tray roll forming machine, faster and more consistent than tray bending lines. 30+ years factory, OEM & custom available.
Tell us your profile, material, and production target — our engineering team will prepare a customized solution and quotation.
